Lighting hardware locker manufacturers introduce the basic specifications for the standardization of custom assembly of European lamps and lanterns

(If there are no special requirements for domestic sales, it will be implemented in accordance with this standard):

1. Classification:

CLASS0 lamps: Lamps that rely on basic insulation for protection against electric shock (basically not produced).

Class I lamps: The protection against electric shock of lamps not only relies on basic insulation, but also includes additional safety measures, namely ground wire protection.

CLASSⅡ: The electric shock protection of lamps depends not only on basic insulation, but also additional double insulation protection (regular requirements of our company).

CLASSⅢ: The protection against electric shock depends on the power supply voltage being a safe extra-low voltage, and no lamps with a voltage higher than SELV will be generated.

Second, the lighting hardware locker manufacturers introduce the basic requirements for assembly:

2.1 All electrical accessories must have VDE/CE certification (mark).

2.2 Class I lamps must be grounded; Class II lamps must be double-insulated; nipples and heat-shrinkable tubes are used for internal wiring to enhance insulation; the outlet of the lamp body is protected by rubber particles or yellow wax tubes; the lower part of the ground wire used must have internal teeth. Slip line, the surface cannot be inverted.

2.3 Use a parachute to strengthen the insulation protection of the plastic lamp tail; the lamp tail must be fixed with screws; the lower part of the terminal block used must have an insulating layer; there must be a locking device. All wires need to be wrapped with terminal blocks (preferred) or welded; the ground wire must be 2-3CM longer than the outlet wire; the wires used must not be damaged and the connection is firm; lamp head outlet: base to switch 30CM; floor lamp outlet: base to switch 50CM;

2.4 Tilt test: 15 degrees for table lamps, 8 degrees for floor lamps;

2.5 Lamp body test: withstand voltage test; on-off test; grounding test, etc. (high standard test); withstand voltage test: Class I lamps: 1500V; 10 mA; 1 second (the company's lower standard); Class II lamps: 4000V; 10MA; 1s

2.6 The desiccant should be put into the inner plastic bag; label requirements: watt label; country of origin label, etc.; manuals should be placed in the parts bag; wood screws; expansion screws, etc.;